Blogs

I’m going to assume you have your CB1 already setup and can access it with SSH. If not please follow the official documentation. Remember to install klipper, moonraker, mainsail etc, i recommend using kiauh. Prerequisites Unless otherwise stated all commands are done whilst logged into the CB1. Whenever the “bridge mcu” is reset, Linux will disable the corresponding can0 interface. To ensure proper handling of FIRMWARE_RESTART and RESTART commands, it is recommended to use allow-hotplug in the /etc/network/interfaces....

The orbiter filament sensor is an add-on for the orbiter extruder it features Filament runout sensing Filament auto loading Button for filament unload The creality 4.2.2 mainboard lacks the regular runout sensor plug, luckily for us we are using a bl/crtouch so the z-endstop header is unused. The wiring configuration is as follows: Blue - GND Red -> +3.3V* Green -> Filament Sensor Yellow -> Filament Unload *The VCC on the creality 4....